2/18/2024 0 Comments Gripper instalingDue to the large opening and uneven load at both ends of the conventional hydraulic elastic clamps, the telescopic action of the hydraulic cylinders on gripper both sides is out of sync. At present, there are few researches on gripper of coal mine rig. Some GT users prefer not to install the back gripper channel if they use the Youth Platen to print on a lot of thicker items.īelow is a video showing how to install the Gripper Kit on an GT Adult Platen (14″ x 16″ size).Clamping device is an important component for automatic drilling machine. You do have the ability to adjust the platen height that much. This will keep the gripper channel far enough away from the platen support arm on the GT printer to allow you to adjust the platen height.įor the Youth Platen, the height adjustment will be minimized because there is less room to work with. When attaching the back gripper channel on the Adult Platen, please make sure that you place the gripper channel on the edge of the platen. NOTE: It is important to place the side channels (15″ in length) just inside where the metal hanger attaches to the acrylic top. Step #4: Center Front & Back Grippers between Side Grippers. Step #3: Place Side Grippers Just Inside the Hoop Ring and Down the Side of Adult Platen. Step #2: Remove the Liner from the Adhesive Tape Foam. Step #1: Remove the Protective Wrapping from Gripper Channels. Below is the written installation instructions for installing the Gripper Kit on to the bottom side of a GT platen.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |